When I made the brake lines for the rear subframe a few months ago, I was not happy with the smaller line on the RHS of the rear subframe due to the pipe bender not being able to bend a very tight radius.
I purchased another pipe bender from the USA (Imperial brand. Model 364-FH-03) that has a bend radius HALF of the first one I bought.
The new line is much neater with the tighter bends and should make for a neater engine bay, especially around the clutch & brake master cylinders.
I purchased another pipe bender from the USA (Imperial brand. Model 364-FH-03) that has a bend radius HALF of the first one I bought.
The new line is much neater with the tighter bends and should make for a neater engine bay, especially around the clutch & brake master cylinders.
Comments
Post a Comment